一、节点构造、构件位置、连接锚固方法，应全部符合设计要求。

1、 The joint structure, component location, connection and anchorage method shall all meet the design requirements.

二、轻质复合墙板的各项技术指标须满足有关标准所规定的要求；胶粘剂的配制原料的质量须符合有关规定；

2、 The technical indexes of light composite wallboard shall meet the requirements of relevant standards; The quality of raw materials for adhesive preparation shall comply with relevant regulations;

三、增强水泥空心条板其四边的粘结必须牢固。

3、 The bonding of four sides of reinforced cement hollow slab must be firm.

四、轻质复合墙板所有接缝处的粘结应牢固，应填塞密实，不应出现干缩裂缝。

4、 The bonding of all joints of light composite wallboard shall be firm, and it shall be filled tightly without shrinkage cracks.
              

五、吊挂点埋件必须牢固。

5、 The embedded parts of the hanging point must be firm.

六、门窗框与门窗框板之间用电焊连接时，焊缝的长度应大于或等于10mm，焊缝厚度不应小于4mm。焊缝表面平整，无烧伤、凹陷、焊瘤、裂纹、咬边、气孔和夹渣等缺陷，其焊点表面应凹进板面3mm。

6、 When the door and window frames and the door and window frame plates are connected by electric welding, the length of the welding seam shall be greater than or equal to 10 mm, and the thickness of the welding seam shall not be less than 4 mm. The weld surface shall be smooth without burn, depression, weld bead, crack, undercut, air hole, slag inclusion and other defects, and the weld surface shall be 3 mm concave into the plate surface.

以上就是轻质复合墙板质量验收标准，当然以上的验收标准只是现在的，以后会根据实际情况进行更优异的改进。

The above is the quality acceptance standard of light composite wallboard, of course, the above acceptance standard is only now, and will be improved according to the actual situation in the future.